Show us Your Interchanges!

[_Michael 2,681]

1 minute ago, Compdude787 said:

It appears you put a diagonal RHW directly over a 45-degree FlexFly. And I believe that that crossing isn't currently supported. You're going to have to re-do your interchange slightly in order to fix that. Sorry, I know it's annoying to have to rework an already completed and MMPed interchange, but I don't think it will function properly unless you do this. I'm not sure if the paths will work.

I was aware of that when building it, and after trailing various solutions in the construction phase, this version made the best looking and most effective interchange. The paths don't work, but sometimes, appearance over functionality.

[Haljackey 17,271]

Halton interchange tour

(in no order)

[TrickyMario76543 67]

3 hours ago, Haljackey said:

I see a few brown boxes, other than that, good job.

 

[jray1981 5]

Excellent work!

While I am pretty much a newbie in my infancy, stuff like this makes me wanna re-do all of my work and start over, with transportation setup as the starter. 

Hopefully I get to the point where I can share as well, but for now, count me among the group thanking y'all for taking time to post n share, as they do inspire us out there!

[Mandarin(a) 35]

It's funny how the interchanges are (almost) the only place with trees in the city. Great work otherwise

[europe.au 13]

All of these interchanges... Never fails to amaze me how these people do it!

[123deoliveira4 32]

13 hours ago, europe.au said:

All of these interchanges... Never fails to amaze me how these people do it!

In a hard work, for sure. Excellent works!

[TakemeThere 5,833]

Spaghetti Junction, NAM 34 rebuild





 
 

[Cmonster59 103]

Is this interchange even Possible in Sim City 4. If so can I get some guidance on that?

[Lost Realist 762]

You are definitely  going to want to increase the scale by quite a bit. As tight as you're trying I'm pretty sure it's not gonna happen.

[Haljackey 17,271]

9 hours ago, Cmonster59 said:

Is this interchange even Possible in Sim City 4. If so can I get some guidance on that?

 

3 hours ago, Lost Realist said:

You are definitely  going to want to increase the scale by quite a bit. As tight as you're trying I'm pretty sure it's not gonna happen.

All I can think of is:

 

 

 

That's the interchange that was used in the movie Speed. Your incomplete ramps reminded me of it .

 

The Mythbusters also tested this jump

http://www.dailymotion.com/video/x2n91sy

 

[TrickyMario76543 67]

Finished building a new exit ramp for my city's highway system.

Also partly decorated the junction.

[Compdude787 916]

On 3/27/2016 at 8:43 AM, Cmonster59 said:

Is this interchange even Possible in Sim City 4. If so can I get some guidance on that?

[insane interchange in LA]

Holy crap. I can't believe you're trying to recreate that sucker. I truly wish you the best of luck, though!

[ROFLyoshi 1,760]

On 28/03/2016 at 11:56 AM, Haljackey said:

 

All I can think of is:

 

 

That's the interchange that was used in the movie Speed. Your incomplete ramps reminded me of it .

 

The Mythbusters also tested this jump

http://www.dailymotion.com/video/x2n91sy

 

And in turn, that reminded me of this: https://41.media.tumblr.com/tumblr_lmhteaCpy81ql8lr5o1_500.jpg

[philforhockey51 4,203]

@TrickyMario76543  Good Start    Just a couple of suggestions:

 

[TrickyMario76543 67]

I've downloaded a slope mod, I've yet to install it though.

[Cmonster59 103]

Currently Under Developement

[drpfaff 54]

Parclo Roundabout Interchange all On-Slope. Took quite a few tries to get an interchange that would work between the small downtown area, the water, and the edge of the map. Initially I wanted to do a some kind of spaghetti junction, but ran out of room too fast. The result is still pleasing.

[ROFLyoshi 1,760]

Sometimes you need an interchange that's not quite an interchange. Allows for traffic to travel in MOST directions.

[Cmonster59 103]

Continuing Development

[TrickyMario76543 67]

10 hours ago, ROFLyoshi said:

Sometimes you need an interchange that's not quite an interchange. Allows for traffic to travel in MOST directions.

How did you get the GLR-on-Avenue with Rail viaduct piece?

[ROFLyoshi 1,760]

3 hours ago, TrickyMario76543 said:

How did you get the GLR-on-Avenue with Rail viaduct piece?

It's in the GLR-in-Avenue menu. You will need to tab ring for quite a while to get to it.

[Haljackey 17,271]

Parclo interchange built during the RHW 3.0 era

 

[drpfaff 54]

Before and after of an interchange in the main industrial district of the same city as above. Before was NAM 32 era diamond interchange, and that has been upgraded to an on-slope interchange, one part windmill, one part parclo. Might also try to re-introduce the tram system that I had before and increase the slant of the main freeway to add some more FAR or diagonal ramps.

Before:

 

After:

 

 

 

[Cmonster59 103]

On ‎4‎/‎1‎/‎2016 at 6:40 PM, Cmonster59 said:

Here's My Interchange. This is not the Judge Harry Pregerson Interchange from Central Las Angeles.

 

[Cmonster59 103]

[Compdude787 916]

17 hours ago, DrPfaffinator said:

Before and after of an interchange in the main industrial district of the same city as above. Before was NAM 32 era diamond interchange, and that has been upgraded to an on-slope interchange, one part windmill, one part parclo. Might also try to re-introduce the tram system that I had before and increase the slant of the main freeway to add some more FAR or diagonal ramps.

Before:

 

After:

 

Images are not showing up for me.

[Haljackey 17,271]

Adding double exit lanes on a busy folded diamond interchange.

All images available full size.

Before:

In progress:

-Lighting also being replaced.

Done:

-Had to use a OWR TuLEP slip lane to keep the EB to NB ramp. Doen't look the best, but gets the job done.

Other images of the junction.

-Zoom ins, other angles, and whatnot.

 

Edit: timelapse video of traffic

 

  Edited April 10, 2016 by Haljackey  
Add video

[drpfaff 54]

7 hours ago, Compdude787 said:

Images are not showing up for me.

Try this again.

[Cmonster59 103]