svachon
-
Content Count
168 -
Joined
-
Last Visited
-
I cannot find my Traffic Simulator Tool to make NAM traffic changes anywhere. I found it when I initially installed the NAM and changed my setting but now I can't find it. I'm in the NAM folder/traffic configuration tool and I thought it might be the TSCT.Jar file but it doesn't open.
-
In a large tile/city do you even care much about congestion? It seems that it's always there with no real impact or am I wrong?
-
I have a large tile city of about 400K sims. It has 3 bridges, 2 regular and one avenue. They are all connected to streets on both ends. On two of them I am not getting any traffic at all. How can this be possible?
-
No on education shifts. It's around 175 the entire time.
-
I have 2 adjacent cities that have a lot of HT jobs. Could that be siphoning off R$$$ jobs and draining C0 jobs from the main city???
-
Oh wait that's look like a ferry route. My bad. Mostly concerned about the C0 though.
-
Also have a weird thing going on in main city with income. Wild wings in income and really not much income at all. The city seems health otherwise.
-
I have one city with heavy HT my large/central city had non until recently I added some but not that much. I have multiple transportation connections in every city. Taxes for Co are at 7.5. R$$$ desirability is fine also.
-
I have a region of 1.3M Sims with 3 large tiles connected with each over 300K and the largest at 500k. Only one city has a small amount of Co demand. Most are pegged low and have a lot of Cs demand, education is usually between 160-180 in the largest cities. When should I start seeing Co demand? Also same region (below) all of a sudden it shows on the regional map, a weird highway lines running in the water.
-
Thanks!
-
I thought I've read somewhere where bus stations should be separated by one tile from a train stations. Is this true because it's much easier to put them right next to each other.
-
My NAM puzzle pieces are so light (almost ghosted) that I cannot make out what they are? It's almost unusable at this point. Any suggestions?
-
OK so I figure out how to change the map size to 1025x1025. I now Cnt-Alt-Shift-R and hit OK and nothing happens. The map just stays the same green blank map with no images on it.
-
When i try to load a new region using Cnt-Alt-Shift-R I get the following Region Generation Error - Region Bitmap size is incorrect. 1537x1537, should be 1025x1025. How do I fix this?
-
Right but I don't have 2 rows.
