NAM single-side parallel ramps bug?

[unseen4ce 36]

I tried connecting to a ground highway using the single-sided parallel ramps, and as I moved the cursor towards the highway it just wouldnt match up as it should. I tried rotating the piece but it wouldnt line up and couldnt be placed. Pic below.

I found a video demonstrating the way it used to work. I did everything exactly as the video, same depth, same pieces.

At approx 2.00 minutes you will see him place the same piece, it just clicks into place easily.

 

[unseen4ce 36]

I have tried another area and still couldnt get it to work. I then tried to attach to a highway that was oriented diagonally and it worked. It doesnt look right but it did work on the diagonal for some reason. So I dont think it is working properly. It should be working on the orthogonal not the diagonal.

The ground around the piece was all level except for the sunken highway before the piece was placed.

 

 

[rsc204 21,805]

On 07/04/2020 at 9:57 AM, unseen4ce said:

I tried connecting to a ground highway using the single-sided parallel ramps, and as I moved the cursor towards the highway it just wouldnt match up as it should. I tried rotating the piece but it wouldnt line up and couldnt be placed. Pic below.

Are you sure you have the piece with a "Road" connection, not OWR, they look remarkably similar. Try tabbing through the menu until the road connection locks onto the road itself when being previewed. Nothing has changed with these pieces since they were created, but it does take a bit of playing around to familiarise yourself with them.

[unseen4ce 36]

After some practice I did get all of them to work.