Region view alignment

[Mart95 0]

Hi, I'm creating a region map in SC4 Deluxe, but I get this strange alignment between cities in north-south direction. East-west seems to be ok, as shown in the attached picture.

It looks like it may be connected to using large sizes of the cities.

Also it occured both when I was doing 4x4 large map from scratch in SC4, but replaced config.bmp with all blue pixels, and when I used SC4 Mapper.

Anyone had that problem too?

Thank you!

[CaptCity 4,684]

That is something that usually results from rendering maps at high resolutions (1600x1200 and above). You might try to lower the resolution then enter and resave each city. You can then use a higher resolution to play the cities. If that does not work, you can try to re-render the map at a lower resolution and switch to a higher afterward. Hope this does it for you...

Also... moving to the Mapping Community Board...

[Mart95 0]

CaptCity,

Thank you! That was the problem. I had 1600x1200 resolution and after I lowered it the problem is now solved.

I'll see later how it works with returning to higher res.

[xelanamyt 0]

I tried doing the same thing and while it does work at a lower res it will come back if you use a higher res and then load/save a city. Annoying isn't it!