Exporting error

[9988 428]

I have problem. I make an building, and if I try to export it from BAR, it comes to 9%, it will stuck and BAT will start to be not responding. With every model and every quality. All other programs are closed. I have relatively fast computer. What can be a problem?

[Sgt Pepper 864]

Well this actually belongs to BAT Open Discussion and I'm sure in one of the pages of the BAT Troubleshooting Thread has the solution but I'll help with any way I can.

First, I'd like to ask what do you mean by exporting it from "BAR"? Or is that just BAT misspelled?

Second it may look stuck at 9% or any other number but it doesn't change any higher until the current rendering image displayed is completely finished. Also you have to be patient and wait and not interupt it. If you do anything where it gets stuck or doesn't respond, just wait. The rendering is actually continuing despite that the bar going down on the rendering image isn't moving(or the whole window with the rendering turns white). Basically, it takes patience. Especially with larger models(even smaller models sometimes).

Hope this helps!

[9988 428]

Thanks, this works, but when I get to 13%, it write "Export failed, source code 6" What is it?

[CaptCity 4,671]

Moving to BAT - Open Discussion.

[simcity 4 fan123 0]

Have you tried re-installing BAT? Have you installed the update for BAT?

[mntoes 270]

https://www.simtropolis.com/forum/messageview.cfm?catid=37&threadid=87425&enterthread=y&STARTPAGE=2

Error code 6 is mentioned in this thread. Do a more thorough search and you'll probably get your answer. Hope this helps.