MIS L1 Over RHW

[kmad1988 3]

Hi i want to put a MIS Level 1 road over the RHW 4, i have a ground to level 1 MIS Slope  but can't find the piece to go over the RHW 4 to connect to the slope on the other side. I've searched through all pieces and cant find what i need. Any help would be appreciated. Thank you

[jabcool52 37]

Just drag RHW-2 between them.

[redfox85 659]

You are using the shorter puzzle piece version of that ramp found in the Multi-Highway (MHW) menu. As such - there is no puzzle piece for L1 MIS over RHW-4. There are multiple ways to proceed, I'll list two.

a) The simplest is to use the Flex Ramp. You will need to place a starter at the end of one of the two flex ramps to convert it from RHW-2 to MIS.

b) This is the one of many complex ways - but when using those ramps this is the most stable. Here is the starting point... a blank slate:

Next, place one L1 3 tile MIS Ramp. After that - destroy three tiles on the opposite side with the middle tile aligning with the ramp. Now use a L1 MIS Starter directly over the remaining RHW-4. And place a ground MIS at the end of the other ramp. It should look like this:

Now, drag out the remaining RHW-4, place a MIS L1 starter over the RHW-4. Place a the three tile L1 MIS ramp, and then the starter. Here is another image for you:

And that's it - its finished.

 

 

[kmad1988 3]

thank you both i did manage to sort it in the end. so much easier being able to just drag it through