rhw pieces drag

[rick1993 0]

hello all, 

 

I'm working on a few rhw tutorials and see many people rhw pieces "drag" I can not drag but only popping. here is a solution? 

 

regards, 

Rick 

 

Apologies for my english, i use google translate

  Edited June 27, 2014 by Cyclone Boom  
Topic moved as this is related to transit modding (NAM).

[MandelSoft 2,769]

Can you check the following?

- Can you drag the basic RHW-2 network? This should not require any starters.

- Have you specifically used the RHW tool to drag out the RHW from the starters?

- Where did you start dragging from? An image would be helpful.

- Have you installed the NAM32 correctly. If you selected "RUL De-coupling" on installation, this might give some problems. Please don't select it to ensure that all RULs get properly installed.

Best,

Maarten

[rick1993 0]

I NAM again originally executed suffering and the problem is still not resolved. 

I can drag the rhw 2 but not the rest. When installing I am not "The RUL-Coupling encountered. 

attached a picture of the rhw 4, the arrows are the strarters. and the rest is fillers

 

Sorry for my english I translate used

 

 

[Tarkus 6,931]

As described in the users guide, with the starter pieces, first, you plop just a single piece, then drag the base RHW network tool (the RHW-2) through the starter.  Do not attempt to "drag" the starters.  All other NAM starter pieces work on this exact same principle, where there's a base network you drag through the starter, so once you get the hang of this, you'll have a lot more options at your disposal.

 

-Tarkus

[rick1993 0]

i tried to drag the rhw on the rhw 4 starter and is it correct that the rhw 2 changes in the rhw 4?

[Tarkus 6,931]

Yes, the RHW-2 will change into RHW-4 when you drag it through the starter.

 

-Tarkus