Sunken Highway T-Intersection

[tikkytik 4]

Can anyone explain how to make a t intersection or any type of highway exchange for a sunken highway?

I can only seem to make a sunken highway in a straight line. I don't know how to make it turn to the right or left and cannot for the life of me figure out how to make a t intersection so I can get the thing going in different directions.

Thanks

[CaptCity 4,670]

Assuming you have used the hole digger lots to create the straight sections, you can use street or road pieces to level the terrain. Just plop them at the ends of the straight section in the direction you want to go.

Then drag the highway.

You can also plop them to make larger areas where interchanges will be used.

Hope this makes sense and is what you're asking...

[tikkytik 4]

Hey Capt, thanks for the reply. Yes that is what I was asking and after reading what you said I went back in and tried it and it worked!

I'm still having a bit of a problem in one area though, and I think it is because the slope is too high where I am trying to use small road pieces to lay out where the highway will go. I get to a point where I try to put them down and it turns red and says something about the slope.

But yes that is what I was asking and I appreciate the answer. It did work, I just need to make some changes to where I want the highway to go it seems.

Thanks a lot for your help.