Problems creating transit-enabled lot

[totof0306 2]

I'm creating a new lot to enable passengers to get connection between several mass transit types.

I've opened my SC4Model file with Plug-In Manager and dropped it to a SC4desc file (5x3) in the category "...\Buildings\Transportation\Elevated Rail Station".

When I open an already existing GLR-Station with the lot-editor I cannot replace the main building because i can't find my file! (even with help of find-tool)

1. What's going wrong?

2. Morevover with SC4Tool I was able to create stations with ET transit but how do you place the subway transit-point?

3. How can I create an overlapping-lot, means lot of 4x3 but building 5x3 to enable dropping road or street through it?

Many thanks forward for help.

[tungston 19]

If the lot you opened is not as large as your new model, then you need to increase the lot size of the one you opened in the lot editor.

The "overlapping-lot" must be made with the model, you need to make it offset in the gMax BAT, or whatever program you are creating the model.

[totof0306 2]

Thanks for your advice.

What does "make it offset" mean? (I'm using gmax-BAT)

[Vahr 341]

Offset means to move the model over from (0,0,0). Like so:
Centered:

Offset:

Also, you might need to fiddle with the LODs

[totof0306 2]

unfortunately something went wrong with the pics...

Do you mean I should center the not overlapping part at (0,0,0) ?

[tungston 19]

Your scene center will not be at 0,0. You will need to experiment with it to find out how much it is off center. Better yet take the question to one of the BAT forums for more detailed instructions.