4 posts in this topic Last Reply
OK as you can see from the pic I get a red line at the entrance to the tunnel. It looks like it doesn't go through. Not sure if it is or not turned on drawpaths and see nothing for the tunnel.
What you see in the pic is RHW 4 tunnels. I attempted to run RHW through the hill but all I get is red line. I attempted to just run RHW through by dragging it but all I get is the red line. These tunnels I have I got here on the STEX and comes with just about all the networks tunnel entrances.
I have the green arrows shown by the drawpath cheat but you can see there is that thin red line going across the entrance.
Well, the thing is, as RHW doest not allow to make tunnels, I did what pretty much everyone else does, I tricked the original game features to allow me to make tunnels, this worked so far with trains, I made tunnels that go under water and even as far from one point of the city to another, now... The original highways have worked on flat terrain and even more, but there is something I'm making wrong and I can't seem to understand what...
As you can see, the highway allows me to make the tunnel that pretty much goes along most of the city until the other side of the channel.
The train one works just fine.
Now, the other entrance /out is being shown:
However, when I try to drive the cars in or into out of it they can't go on once they reach the shores, something stops them from going on. I even made several other atttemps with the terrain below the water but the trains don't seem to be affect by it.
Does the terrain has anything to do? Did I make it too deep? (As I said before, trains don't seem to be an issue)
Thanks in advance!
First of all let me say I'm new to this forum and to SimCity 4. I installed NAM to my computer with SimCity 4. Now while I was making the highways for the city that I'm working on, I noticed that I couldn't connect an exit from the RHW to lets say an avenue or a regular road or even a street.
So basically I'm stuck at this stage. Any help on where I can find something to connect this to a road would be appreciated. Or is there any way to make an exit with the NAM (with the default ground or elevated highway, there was the option of ramps and that could've been easily connected to the roads. With RHW, I don't seem to find any option like that.)
Good day all, I just installed NAM 36, and I get several questions of NAM 36:
1. Is there any transition pieces to connect between RHW and Avenue? It looks like the median line doesn't match like screenshot below:
2. When I connect MIS to Avenue, why there is no traffic light from the MIS direction?
3. Why the traffic light on my elevated road junction always steady green?
Anyone know what's the problem?
Recently Browsing 0 members
No registered users viewing this page.