Jump to content
Sign in to follow this  

How to get a SC4Model (BAT) into LOT

Recommended Posts

Hi, I finally turn to you. I've been looking for a solution all day I guess.


I've built a house in SC4 B.A.T. (gmax) en saved it (according to a tutorial as draft) leaving me with a SC4model.

After this I ran the Plug-In Manager (PIM) and dragged the house to the R$ section.


In the LotEditor (LE) I opened a R$ 3 2x1 lot and select Building -> Replace... but I can't seem to find my house.


I'm not very familiar with SC4Tool and/or ILives Reader, but the house show up in these programs just fine.


So... please help me.





Share this post

Link to post
Share on other sites

May not find your model do the the size of the model. The lot edit will only show the list of buildings that can fit on the buildings parameters. the best thing to do is to make the lot size a lot larger to see if it comes up on the list. I hope this helps.


- Aaron

Share this post

Link to post
Share on other sites

Thanks. That was indeed the problem. Now, after I inserted it in the LOT, I have to go back to the drawing board and resize the building. It is way out of perspective.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an Account  

Sign up to join our friendly community. It's easy!  :thumb:

Register a New Account

Sign In  

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.